An OpenAction (OpenDeck) plugin to control ham radio transceivers through a hamlib rigctld daemon.
The plugin currently supports only one rigctld connection to localhost:4532.
The following actions are currently available:
| Action |
rigctld Command |
Description |
| Frequency Dial |
\set_freq, \get_freq |
Encoder to tune the VFO frequency in configurable steps |
| Level Encoder |
\set_level, \get_level |
Encoder to adjust a level value in configurable steps |
| On/Off |
\get_powerstat, \set_powerstat |
Toggle the rig power between on and off |
| Power State |
\set_powerstat |
Set the rig to a specific power state (off, on, standby, operate) |
| RIT |
\set_rit, \get_rit, \set_func |
Encoder to adjust the RIT offset, press/keypad to toggle RIT on/off |
| Select Mode |
\set_mode |
Set the operating mode for a VFO |
| Select VFO |
\set_vfo |
Select the active VFO |
| Send Morse |
\send_morse |
Send a preconfigured text as Morse code |
| Set Antenna |
\set_ant |
Select an antenna for a VFO |
| Set Frequency |
\set_freq |
Set the frequency of a VFO to a fixed value |
| Set Frequency (rel) |
\set_freq, \get_freq |
Set a VFO frequency relative to another VFO's frequency |
| Set Function |
\set_func |
Enable or disable a rig function |
| Set Level |
\set_level |
Set a level to a fixed value |
| Set Parameter |
\set_parm |
Set a rig-wide parameter value |
| Set Split VFO |
\set_split_vfo |
Enable or disable split operation and set the TX VFO |
| Stop Morse |
\stop_morse |
Stop the current Morse code transmission |
| Toggle Function |
\get_func, \set_func |
Toggle a rig function on/off |
| VFO Operation |
\vfo_op |
Perform a VFO operation (e.g. copy, exchange, band up/down) |
| VFO Operation Encoder |
\vfo_op |
Encoder with configurable VFO operations for clockwise, counter-clockwise, and press |
| XIT |
\set_xit, \get_xit, \set_func |
Encoder to adjust the XIT offset, press/keypad to toggle XIT on/off |
This software is published under the MIT License.
Copyright Florian Thienel
